Farmall & IHC Tractors Discussion Board |
Re: OUCH!!! Sheared bolt!!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on April 07, 2002 at 16:42:12 from (216.46.130.24):
In Reply to: OUCH!!! Sheared bolt!!! posted by Tim Malin on April 07, 2002 at 15:35:15:
Ouch Tim. Where was the bolt, it must be siezed in tight or it wouldn't have sheared. I would start by heating the remainder of the bolt red hot and then dousing it with cold water. Then take a center punch and punch a mark in the dead center of the bolt, this is the most important part of the process. Then drill a small hole into the bolt , straight and well into the bolt. Go up a few sizes till you can get a good quality easy out into the hole. I prefer square shafted easy outs as they seem to bite in better , but a good easy out will work. If you still can't budge the bolt go back to heating it and the area around it red hot , douse and try again. Now you can use penetrants as well to help. Go easy, you don't want to snap the easy out off or you will have one H of a time trying to drill it out. The problem is the bolt siezed in the hole ,not the fact that the head is gone so work from that theory...get the bolt to unsieze and the easy out will bring it. Let us know how it goes . Also is there enough of the bolt sticking out to get a vise grip on?..even if there is ,use the easy out in combination with the vise grip...good luck from Mike in Exeter Ontario
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|