Farmall & IHC Tractors Discussion Board |
Re: Stuck pistons
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tim Malin on April 01, 2002 at 19:17:24 from (207.190.93.17):
In Reply to: Stuck pistons posted by 54SMTA on March 31, 2002 at 20:45:02:
A 12 pack, plastic block, and a sludge hammer loosened up an F-20. lol I'm a 16 year old student so I know your reactions to the 12 pack, but whatever works, right? lol. All in good fun. Hey, we used several substances from ether to diesel to a product that slipped my mind, and then tapped her for a few hours. No prob after that. Careful, when she decides to come loose it will probably throw the guy with the hammer off balance. It sure did for us. It then hand cranked over like it was never stuck. Still have lots of work to do on it yet.
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|