Farmall & IHC Tractors Discussion Board |
Re: Plowing with an H?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Charlie on March 28, 2002 at 16:07:10 from (209.130.132.133):
In Reply to: Plowing with an H? posted by Krey in Indiana on March 28, 2002 at 15:46:51:
An H can pull 2-16 in plows without a problem. I think you're right about trailer plows doing a better job of plowing but if you have flat fields a 3 pt mounted plow would do a decent job and is a lot easier to get into tight places than a trailer plow. I'm surprised you can't find a good 2 bottom trailer plow. When you say the ones you found are junk do you consider them junk because they need a lot of new parts, wheels, etc or do you have other reasons for thinking they are junk. A plow can look pretty ugly when it comes to paint and tires but if it has good mold boards, coulters and wheels and isn't sprung then the cost to get it working isn't too bad. Rusty mold boards can be cleaned up. It can be very expensive to buy some types of plow points for the older plows.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|