Farmall & IHC Tractors Discussion Board |
Re: Re: Farmall A Steering Arm
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gary on March 25, 2002 at 14:37:58 from (64.66.228.37):
In Reply to: Re: Farmall A Steering Arm posted by Hilltopper on March 25, 2002 at 14:13:13:
I finally hit it in the right place and it came loose. What part of the assembly contributes most to the loose steering? Did you replace the bushings on the steering shaft and on the shaft where the steering sector is? How do you get them out and can a new one be tapped in or do you need a special driver? I was wondering how to inspect the worm gear on the steering shaft and the sector gear for wear? Also cant decide about when a bearing needs replacing and when the old one is OK. Was the key in your steering arm tight and the key in the sector loose? I hope the sector key on mine is loose. That seems like it would be an easier fix than replacing the bushings. There is quite a bit of wear on my steering shaft where it runs in the bushing. Havent taken the sector gear shaft out yet to inspect it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|