Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: Farmall tractor as an investment (please read)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on March 22, 2002 at 14:48:31 from (64.228.12.81):
In Reply to: Re: Re: Re: Re: Re: Farmall tractor as an investment (please read) posted by SAm in NS on March 22, 2002 at 12:23:47:
Sam: Now there is a good chore for a Super A, plowing snow. A super A with a front mounted blade and wheel chains will create envy amoung owners of much larger tractors. I have a 6 foot angle fabricated blade (20 inches high). That is a foot wider than the factory blade. That little tractor will amaze you on the amount of snow it will push. When I was on farm had a 300 with an 7 foot angle blade. Plowing with blade angled on 300 you had to be on brake on side you were pushing, to keep front end from pushing sideways. Super A with 6 foot blade angled, hardly have to touch brake. I knew this before I built my blade. When I had the 300 there was a neighbor with a Super A and factory blade, and he did embarass me.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|