Farmall & IHC Tractors Discussion Board |
Re: C rear axle seals and touch control
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by geoff gauger on March 22, 2002 at 06:02:18 from (12.155.240.196):
In Reply to: C rear axle seals and touch control posted by Charles Norwood on March 21, 2002 at 08:45:26:
Do it right. You will find that the original seal has cut a groove in the axle shaft. If the new seal lands in this groove your leaks will most likely still be there. I'm a little crazy about my restoration work but if I can't position the new seal so that the lip rests on virgin shaft I put the shaft on the lathe and turn it down (in the area of seal contact only) to the next standard seal size. If the inner seal is done right, the outer is fairly irrelevant since the outer bearing is only greased.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|