Farmall & IHC Tractors Discussion Board |
the F14 turns over!!!!! yeaaaaaaaaa!!!!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob Kerr on March 21, 2002 at 12:33:25 from (205.188.193.31):
The F-14 I have listed for sale in the photo ads section now has a freed up chevy 216 engine. It acually wasn't stuck at all, I just didn't have a good pry bar here at the new place, and screw drivers don't work so good. Went back over to the farm last weekend and brought home grandpas old crow bar and put it to the fly wheel,it moved about a half an inch on the flywheel, so I went ahead and pulled the plugs out and dumped in kero and oil mix and spun it over a few turns. It took a total of 5 minutes to get it to turn and that was including getting out the tools!The thing should run with a carb, fuel pump, starter, gen and gas tank cleaned out. It sure made my day! I wonder if I should raise the price now?
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|