Farmall & IHC Tractors Discussion Board |
Re: C rear axle seals and touch control
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ScottyNY on March 21, 2002 at 09:08:18 from (128.59.123.240):
In Reply to: C rear axle seals and touch control posted by Charles Norwood on March 21, 2002 at 08:45:26:
Can't help with the seal question, but the TC head-- if you've got the bolts out, you've got it all. Mine came off really hard, and whatever was used for a gasket sealer was the very devil to get off. If you've got something fairly mild by way of a wedge, thin and with not too much of an angle(like a rigid scraper) that you can use, I expect you'll have better luck prying your way around it than you will bouncing or sliding it. As long as the sytem is drained so there's no chance of a vacuum working on the inside, it should come off, with patience. Good luck! Scotty
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|