Farmall & IHC Tractors Discussion Board |
TA repair vs. rebuilt
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by crockofbc on March 21, 2002 at 04:43:08 from (192.249.47.9):
The TA on my 460 is out on the low side so I'm pretty sure that the overrunning clutch isn't working. Has anyone repaired one of these for less money than you can get a rebuilt for? Case IH wants about $400 just for the ramp assy. Is there a cheaper source? Do the rollers typically wear the cage too? Would you replace bearings and oil seals while it's torn apart? Are there any of the special tools that you really need to do a rebuild yourself? Of course I'm just speculating because it's still in the tractor. Just wondering what I'm looking at in $ and time.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|