Farmall & IHC Tractors Discussion Board |
Re: Installing sleeves
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Matthew on March 15, 2002 at 17:46:58 from (64.68.163.49):
In Reply to: Installing sleeves posted by Mike on March 15, 2002 at 17:34:22:
Use dish soap on the o-rings when you install the sleeve, as oil makes rubber swell the soap will not. Be sure to clean the sealing area in the block. If it isnt pitted or have grooves worn in it, you won't need any kind of sealer. Oh ya, After you install your o-rings be sure to get any twists out with a o-ring pick. Make one full turn around them and that take care of that. Good luck Matthew
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|