Farmall & IHC Tractors Discussion Board |
Re: Re: Re: F20 Crankshaft
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Shawn on March 15, 2002 at 12:56:39 from (208.149.17.140):
In Reply to: Re: Re: F20 Crankshaft posted by Wayne on March 15, 2002 at 05:48:22:
Its the shop service manual, I have the parts manual also. If you have the crank off the book says to remove the rear cover, (the cover contains the rear seal)and than it says the rear bearing cage and bearing assembly and front bearing can be pulled back through the bore in the crankcase. It also states that the front cover has to be removed. I tried to condense a little to avoid rewrting the book. It does show a picture pulling the crank out with a puller. I hope this helps
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|