Farmall & IHC Tractors Discussion Board |
Re: Re: A farmall Drawbar that's
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ScottyNY on March 15, 2002 at 03:05:51 from (128.59.6.172):
In Reply to: Re: A farmall Drawbar that's posted by VAJerry on March 15, 2002 at 01:07:51:
Pete, if you can't track down one of the drawbar extensions that Jerry describes, the Service Manual for the As and Bs has some good dimesional drawings you could use to make one/have one made. I seem to remember reading somewhere that the purpose of the extension was to extend the distance between the PTO shaft and the hitch to an industry minimum standard. Later tractors, like the SuperC addressed that by making the length of the swinging drawbar adjustable. If it fits in with what you want to use the tractor for, another option would be to locate a swinging drawbar. If you did that, the worn hole wouldn't be an issue (you'd center the drawbar with pins through the good holes on either side), except that you might then find you'd have the same thing going with the hole in the swinging drawbar! I also recall a thread a while back on how to fix egg-shaped holes. It may still be in the archives. Good luck! Scotty
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|