Farmall & IHC Tractors Discussion Board |
Re: Separating a 1066 between transmissions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bleedinred on March 09, 2002 at 15:39:22 from (67.227.184.193):
In Reply to: Separating a 1066 between transmissions posted by Mitch Sisson on March 09, 2002 at 15:01:56:
Mitch--I'll e-mail a picture of the 986 version of the speed transmission separated from the rear end. We took the tractor apart at the clutch housing first then pulled the s.t. off with the hoist. Don't see why you would have to dismantle rear end first, as we saw that in the manual also and couldn't see why. If I remember right there is a half moon key on the reverse shaft and I believe you can see that with the side plate pulled off the rear end housing. I would say check that first before you get further into things. My memory isn't too good as we did this in Dec. and it's already March... RPM can you help?
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|