Farmall & IHC Tractors Discussion Board |
Re: How much of a pond can I dig with an M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike Shultz on March 08, 2002 at 16:30:19 from (205.188.197.167):
In Reply to: How much of a pond can I dig with an M posted by Pond Man on March 08, 2002 at 13:07:09:
When I was young, dad used a rollover plow on the back of a case 930 and made 2 good sized pond at a local golf course - just kept going around in circles moving the soil away from the center. Then took a culimulcher over it and smoothed it out. We've also put in water ways this way and it works pretty good going back and forth. I imagine with a 2 or 3 bottom plow behinf the M you could just keep working the soil out from the center and see what happens. If you're looking to go pretty deep, this won't work. MIKE
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|