Farmall & IHC Tractors Discussion Board |
BN front wheel spindle
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ScottyNY on March 06, 2002 at 16:57:13 from (128.59.6.25):
I posted a while back about a spindle that was lightly stripped--the nut threaded until it started to draw up and then just spun. Got lots of good help and the wheel is back on in good shape. BUT . . . the problem stems from the fact that there are no holes in the spindle to run the cotter pin through. It's the left wheel, so it only makes sense that the lack of holes is the root of the problem. So . . . How hard is that spindle? Am I going to need a specialty/hard bit to drill through it? I see a pain in the neck but not nasty project--pull the wheel, clean off the grease so the drilled filings don't wind up inside . . . Will common B&D twist drill bits do the job or should I get a carbide tip? How big for a 1/8 inch cotter pin? Thanks, as always for any guidance. Scotty
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|