Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Farmall wiring diagrams - back on line
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chris Good on March 05, 2002 at 12:50:12 from (128.32.250.111):
In Reply to: Re: Re: Farmall wiring diagrams - back on line posted by Bob M on January 16, 2002 at 18:57:15:
Bob M, I recently restored a 1941 Farmall B. For now lights are working off the battery and ammeter is working. I have a rebuilt 6 volt generator rebuilt and a working 6 volt regulator with two terminals. I am assuming that one of the terminals on the regulator is a BAT connection... not sure what the second terminal is intended for. The generator has two terminals labled A & F. I would like to confirm the proper wiring schematic for reinstallation of the generator and voltage regulator. The link posting a Farmall B diagram does not seem to be working. Any suggestions? I am able to follow written instructions as well.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|