Farmall & IHC Tractors Discussion Board |
Re: Hard time tuning converted M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on March 04, 2002 at 17:31:37 from (216.46.130.44):
In Reply to: Hard time tuning converted M posted by Robert C. on March 04, 2002 at 06:30:20:
Robert, I changed an H manifold from distillate manifold to a gas reproduction manifold and I never touched a thing on the carb, I wouldn't think you would need to. The distillate manifold just has a heat box to heat up the fuel more. My old M still has the original distillate manifold on it..anyway, my experience with the H is that manifolds have little affect on carb settings. You don't need to change the heads, the M will run fine on gasolene and its new manifold..my Dad farmed for 40 years with a distillate M burning gasolene. You need to check your manifold for leaks such as in the gasket or torquing it down. run some acetlene or propane around the manifold as the tractor is idling..if it smooths out when you apply the gases around the gasket ares , then you know you haver a leak...good luck from Mike in Exeter Ontario
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|