Farmall & IHC Tractors Discussion Board |
Re: What's a good 3 pt. plow for an H?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Joe on March 02, 2002 at 10:46:56 from (66.43.207.226):
In Reply to: What's a good 3 pt. plow for an H? posted by Krey in Indiana on March 01, 2002 at 20:02:27:
I would think an H would pull a 2 - 14 pretty well, but i think a 2-16 or 3-14 would be pushing it, depending on what type of soil you are working in. Our 400 pulls a 3 - 14 respectably in our clay and sand, but I doubt that our H could handle it. I am also prefer pull implements - I have never run 3-point ones though. I highly doubt you will flip if you catch up on a rock - the only time I have ever have my front wheels off the ground are when I am pulling large oak logs out of the timber. Just my two cents worth.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|