Farmall & IHC Tractors Discussion Board |
Re: Behlen power steering installation - need help
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by One way to do it. on March 01, 2002 at 07:02:11 from (152.163.213.84):
In Reply to: Behlen power steering installation - need help posted by PaulH on February 28, 2002 at 15:08:24:
I have a Behlen unit on a M and it is a simple job to install. My unit has a Behlen pump mounted behind distribitor like factory or M & W pump. The resivoir is a fabricated steel tank that mounts were small gas tank on distillate model would go. The plumbing goes from bottom of tank to suction side of pump to high pressue side of unit and back to tank. This unit is mounted over valve cover and braced to casting that supports center of steering shaft. The unit fastens directly to shaft from steering wheel but shaft to steering gear must be shortened and new key way cut. This set up works fine but hood must be modified to clear unit and casting it is braced to is prone to breaking. Hope that this might help.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|