Farmall & IHC Tractors Discussion Board |
Re: TA problems
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Rider on February 26, 2002 at 20:41:58 from (67.226.44.24):
In Reply to: TA problems posted by Farmall 400 puller on February 26, 2002 at 17:54:23:
When you in the direct drive of the TA, The TA clutch is engaged and the whole TA planetery assemble rotates. When you pull the TA lever back for the low side you disengage the TA clutch and the planetary assembly actually tries to counter rotate. This is where the overrun clutch (ramp and roller assembly) will lock the planetary assembly to stop it from counter rotating. When these ramp and rollers get worn they will not lock up the Planetary assembly allowing it to counter rotate and your tractor will stop. For your other questing, No it will not hurt to pull your tractor leaving your TA in Direct drive. As far as a TA eliminator kit, there is or was one but I don't know why anyone would go to all the work to remove the TA and put one in. If you split your tractor to install the eliminator kit you might as well just fix your TA. They are very handy.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|