Farmall & IHC Tractors Discussion Board |
Re: CRACKED MANFOLD
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on February 26, 2002 at 16:19:59 from (216.46.130.107):
In Reply to: CRACKED MANFOLD posted by CHUCK on February 26, 2002 at 12:42:31:
Chuck, Scotty could be right about the space between each bolt hole between tubes, they are designed that way ...but if it is a cracked manifold you may as well get out your wallet because the tractor will never run right. The manifold will suck air making carb settings impossible and the tractor will always seem to have a miss in the RPM range. I put a new manifold on an H last year and the improvement was beyond description. I paid$190 Canadian for the reproduction manifold and I am very pleased with it...that H is now the best running tractor in my barn..starts in below zero weather, never stalls or misses....an old tractor collector friend of mine (over 40 Tractors) says a tractor is only as good as the manifold on it..draw your own conclusion..oh yeah, you can swap a manifold in less than half an hour and thats heating the cap screws with the torch so you don't twist one off...good luck from Mike in Exeter Ontario
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|