Farmall & IHC Tractors Discussion Board |
Hydraulic connections on IH 340 Util
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom Wieseler on February 26, 2002 at 07:15:09 from (137.38.224.18):
The Tel-A-Depth system on my IH 340 Utility is gone except for the hyd connection block that is located behind the seat (actually, this appears to be 2 blocks that are bolted together). On this block assembly, a 1/4" steel bypass pipe is currently installed between two of the topside ports. However, there are 3 additional ports on this block that are unused and plugged (one more on top, and one out of each side). I'd like to connect a woodsplitter (that has its own hyd control value) to this block assembly. Should I connect the woodplitter where the bypass is currently installed, or should I use a different configuration? Any help would be appreciated.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|