Farmall & IHC Tractors Discussion Board |
Re: Re: pneumatic lift for A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by DAVE C on February 20, 2002 at 19:43:16 from (209.197.177.144):
In Reply to: Re: pneumatic lift for A posted by Andy on February 18, 2002 at 17:29:11:
we have a 44 A with exhaust-lift.Andy`s point is well taken,but only if the control-valve is not functioning correctly .you can check this on the A you are looking at by seeing if it has a neutral setting working,between lift and lower on the control.this should allow the implement to continue to be raised while having the exhaust exiting the muffler instead of backing up against the exhaust valves.the raising of the cultivators puts exhaust-pressure into the cylinder and should not harm the engine.this also allows you to "inch" up and down as needed.a manual that i purchased from Gensales also included information on the exhaust-lift system. good luck on your purchase!
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|