Farmall & IHC Tractors Discussion Board |
Re: 1943 Farmall M Starter Switch Location
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Dukester on February 17, 2002 at 20:38:26 from (65.89.19.220):
In Reply to: 1943 Farmall M Starter Switch Location posted by O2W on February 17, 2002 at 12:42:13:
Dear old IH put those switches in different places on tractors as the years went by. It's kinda curious why they did this, there was usually some reason other than to create arguments about peculiar characteristics of different year models of the same tractors. I even heard a reason why they went to all metal belt pulleys. I think one of the worst mistakes was doing away with the 4 position-seperate-rim-wheel front wheels like the tractors had up until '58 and going to those cheap reversible disk wheels of the later years. That's just my opinion--it don't mean it's right.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|