Farmall & IHC Tractors Discussion Board |
Re: Re: Governor help on IH 140
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on February 15, 2002 at 06:18:57 from (129.37.117.170):
In Reply to: Re: Governor help on IH 140 posted by doug stockman on February 15, 2002 at 03:12:51:
I have a C and an A "Shop Mule". I adjusted both per the manual. Before I did that, the C would not go back to low idle. After I adjusted the linkage per the manual, I had a surge on the C and then had to adjust the bumper spring to get rid of that. They both run fine now, but I notice that they don't seem to have the power under heavy load that they used to. I think it is because the governor spring is old and has gotten a little weak. The spring pulls against the centrifugal force of the weights, so if the spring is weak, the RPM has to be a little lower before the spring can pull the throttle open.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|