Farmall & IHC Tractors Discussion Board |
Re: transmission oil in a farmall c
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmall Freddy on February 12, 2002 at 16:56:57 from (205.188.200.164):
In Reply to: transmission oil in a farmall c posted by jimmy on February 12, 2002 at 15:23:29:
There are five (5) plugs on the transmission/rear end/PTO/belt pully. 1. The filler plug located on the top plate just below the guages. 2. The drain plug located on the bottom of the rear end housing. 3. The Oil level plug located on the right side of the rear end back of the axel housing. 4. The inspection plug located on the top of the power take off/belt plully housing. 5. The drain plug for the PTO/Pully located just to the right of center, below what would be the pully shaft, on the back of the housing. If you mistake the drain plug for the belt pully for the level plug you would over fill the housing. The capacity is 5 U.S. Gallons. For tractors w/PTO and 1 quart less for tractors without. Hope this helps
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|