Farmall & IHC Tractors Discussion Board |
Re: Noise in Cub transmission housing
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by George Willer on February 09, 2002 at 07:59:19 from (64.254.131.77):
In Reply to: Noise in Cub transmission housing posted by David Jr. on February 08, 2002 at 09:39:30:
David, They all make a little sound, but it is a matter of degree. Have you run your Cub fast enough to splash the oil around in the case? There is a set of galleries to drain the oil back through the vital places. There are 3 bearings that will be turning, including the PTO bearing. Is the noise any more or less when the PTO is turning? The roller bearing at the rear of the transmission is the most likely cause of noise, due to lubrication problems. They are often assembled with an oil hole covered, causing the rollers to erode the shaft. Pull the cover and see if you can get any oil to it, just to see if it quiets down. George Willer
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|