Farmall & IHC Tractors Discussion Board |
Re: C 3-point hitch
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by IN Jones on February 08, 2002 at 05:24:15 from (63.146.82.81):
In Reply to: C 3-point hitch posted by Charles Norwood on February 07, 2002 at 19:47:40:
I've had a Saginaw 3pt on my SC for awhile. As far as breaking something, I think the axle clamps themselves would be the weakest link. I could see them poping apart if you were to hit an im-moveable object like a big stump. But that would be good. Better that than an axle. I can't quite picture anything on the Saginaw hitch breaking. I don't plan on doing any ramming type work with this rig like I do with my other tractor. The setup works just fine with normal 3pt attachments. The most I've lifted is about 600 lbs with a rear scoop. Even then the front end stayed on the ground without any extra weights. It did feel like I had power steering though.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|