Farmall & IHC Tractors Discussion Board |
Re: cub hydraulics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by David Sr. on February 07, 2002 at 09:48:48 from (216.34.188.35):
In Reply to: cub hydraulics posted by Tony on February 07, 2002 at 07:57:05:
Just a note: If you find that you need to replace the o-rings in the unit, good luck. 95% of them can be gotten in a rebuild kit, but there's one in the kit that we bought that didn't fit right and was damaged when we assembled the unit, so it leaked. We have been everywhere, and that particular o-ring, the one on the control shaft, is hard to find. Everything that comes close is either too big and won't fit in, or too skinny and leaks. Be careful with the strainer if you disassemble the unit too.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|