Farmall & IHC Tractors Discussion Board |
1950 Cub Timming, with stock IH, Mag
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Cubby50 on February 07, 2002 at 09:21:54 from (152.163.201.207):
#1 up both valves closed Crank pully notch at pointer on block. Pulled cap and the rotor is about 3/4" past #1 plug wire. seems to me that this is retarted by so many degrees. Good hot blue spark, point fine and set, cap in good condition, new wires, new plugs D-18Y Champions. The tractor seems to be low on power, this could be because of a retarted condition. Can any one walk me through the timming procedure. This unit calls for firering at Top Dead center Thanks Cubby 50. The information in this forum is really great. Thanks again
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|