Farmall & IHC Tractors Discussion Board |
Re: Timing an H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmer Bob on February 02, 2002 at 17:47:55 from (66.152.73.188):
In Reply to: Timing an H posted by Dick Davis on February 02, 2002 at 15:51:28:
Dick, I hear ya with this problem. The marks have to be there and maybe you just haven't had enough light to see them yet. (Yes the lifters on #1 cycl. should be all the way down when #1 is at TDC on compression stroke). Use brake Kleen to clean the face of the gears and look for either small round punch marks or small hyphens like - -as my Super C had. The marks will be right at the base of the notch between the teeth or on the tooth itself. If all else fails use the side of a piece of childs chaulk and do sort of a pencil shading on the face of the gears. That may bring out the marks.//FB
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|