Farmall & IHC Tractors Discussion Board |
Re: Its rebuilt, it starts... Now ????
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by F14 on January 25, 2002 at 15:05:55 from (216.204.137.33):
In Reply to: Its rebuilt, it starts... Now ???? posted by Will on January 25, 2002 at 14:51:35:
I ran mine for 15-20 minutes, around the dooryard, checking for oil or water leaks and watching the temperature. Let it cool, retorqued the head bolts, snugged everything else up, and ran it for another hour here and there, then changed oil and filter. For the first 20 hours or so of engine time (a guesstimate) no heavy hauling, more because I didn't have any to do than from any master plan. When I finally did hitch her to a plow and run her hard enough to have to open the shutters to keep her from overheating, she pulled like a bull, considering she's only 14 horse. Unless you're planning on farming with it, just run it, you'll be fine. Do retorque the head bolts after the first time you get it up to temp and let it cool down, and change the oil and filter fairly soon to get any debris from the rebuild that might have hidden from ya. Cheap insurance.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|