RDJ: The cultivator is a shade less than 6" wide. There are 17 shanks spaced on 4" centers. These are on three tool bars.
Since the photo I've added gauge wheels at the back. If you drop this cultivator as deep as it will go, it will stop a 100, 130 or 140 on the spot. Before I added the gauge wheels, I'd get into trouble if rear tractor wheel went through a hollow. I designed the crumbler so I just hitch it behind. I didn't want to add a lot of weight by having crumbler mounted directly on back of cultivator.
I bought the shanks new, complete with clamp and point for just under $10. per shank. You have to watch the clamps you get with S-tines, some are designed to clamp tight on 1/2"x2" steel bar and some require 5/8"x2" to keep them tight. If I remember correctly it's the original Danish S-tines that use 1/2"x2 and US replacement that use 5/8"x2" My clamps are for 5/8"x2".
When I built this close to 20 years ago, the smallest factory S-tine cultivator was 8'. There weren't a lot of used one's on the market back then. I didn't feel like taking the torch to an 8' cultivator to make it 6'. Put it this way I built the whole cultivator for less than $500. I couldn't see paying $900. for an 8' I had to cut down then add a fast hitch fork.
I see used 8', S-tine cultivators go in auctions today for $200. I wouldn't build one today, just go to a consignment auction, about the only guy your bidding against is scrap dealer, he has a percise cut off.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
