Farmall & IHC Tractors Discussion Board |
Re: Super A vs. Cub cultivator dimensions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by SuperA-Tx on June 21, 2007 at 19:12:07 from (4.226.55.179):
In Reply to: Re: Super A vs. Cub cultivator dimensions posted by georgeky on June 21, 2007 at 07:56:21:
George, (In my opinion) Those are the clamps that work on the SA on the front mounted culivator. It isnt for the 144 cultivator but mounts in the same place. My cousin calls them a "round beam cultivator" but I dont know the actual name. The tool bar extension is round instead of square then the 1 3/8 bar is mounted to it with a kind of U bolt. It is mounted at an angle like an industrial axle is. The clamps attach the shanks of the cultivator to the diamond tool bar. Anyway, after further (accidntal) research the the tool bar for the Cub is the same as the SA, both 1 3/8. Shanks are the same as well. http://www.cleancomputes.com/Cub/Cub%20Implement%20Manuals/Cub-144%20Cultivator/Page%2026.jpg
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|