Farmall & IHC Tractors Discussion Board |
Re: farmall 140 rear drain/weep
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on June 10, 2007 at 12:05:06 from (209.226.106.176):
In Reply to: farmall 140 rear drain/weep posted by Jimcapone on June 10, 2007 at 06:52:02:
Jim: You have over filled the transmission, causing the lub to go through axle seals. The transmission case has a system to prevent this oil from going to the brakes. The oil you are seeing is that over flow. On the left side of transmission case there is a fill to level plug direvetly below front tip of left fender. Usually it is behind brake pull rod. I always fill my tractor to that level plug, then add a quart. You may ask why axle seals leaked, you probably have oil level above them. I think once you take it back as I suggest the leak will stop. May take 2-3 days. You should never have to add oil to the PTO, there is a gear that puts oil up there and an overflow to allow the excess to drain back to transmission, thus all the oil you added is now in the transmission.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|