Farmall & IHC Tractors Discussion Board |
Questions on overdrive and misc. on 1938 F-14
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by migraine on June 06, 2007 at 08:50:09 from (71.231.54.158):
Just got a 38 F-14 in with 2 speed mounted between clutch and trans. with rod going through back to L shaped handle to shift. This handle sits next to the steering column and the box has numbers H262-1 on it. Can't see any other nos. but they may be there under the dirt or? Has gas starting tank on top with cutoffs changed to rubber and has hydraulic lift mounted on floorboard. Runs good but needs some carb. work.Just curious what 2 speeds they used back then and how these tractors were set up. Supposed to have overbore kit from a Super C in it and has had quite a bit of other work done on it the last few years. Thanks for any help and insight you can give me. Migraine
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|