Farmall & IHC Tractors Discussion Board |
Re: M W 9speed for H
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by r4etired on June 01, 2007 at 17:43:31 from (152.163.100.197):
In Reply to: M W 9speed for H posted by Dave S. on May 31, 2007 at 20:15:57:
The cable hole should be drilled in line with the top transmission internal threaded bolt.Stay backfar enough not to kink the cable inside the housing,going back to far will make a sharp bend to mount the control on the light bar. Make sure your cable is good,not streched and is adjusted properly,Many failures were caused by the shifting gear not engaging all the way and rounding off the direct and OD gears. NAPA has a truck pto cable that is the correct OD to thread in the pass through bolt, I leave the rubber coating on the exposed portion.
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|