Farmall & IHC Tractors Discussion Board |
Re: swing cylinder,backhoe
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by glennster on June 01, 2007 at 10:56:56 from (76.224.16.173):
In Reply to: swing cylinder,backhoe posted by colevan on June 01, 2007 at 08:55:52:
first check if the control lever is avtivating the spool valve. then i would crack the hydraulic lines loose a little where they go in the cylinder. then operate the swing controls and watch where the fluid comes out of the lines. just nudge the controls, you dont want to spray oil everywhere. that way you can see if you are getting flow to the cylinder itself. is the motor straining when you try and swing the bucket?? could be the cylinder is frozen. if you got fluid at both lines, last resort would be to disconnect the lines at the cylinder and use a come along to swing the bucket and see where the fluid comes out. then hook the lines up accordingly.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|