Farmall & IHC Tractors Discussion Board |
Re: 560 -- Stuck in 2 gears or other problem...hel
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on May 31, 2007 at 18:56:44 from (66.216.226.55):
In Reply to: 560 -- Stuck in 2 gears or other problem...help... posted by Clefus on May 31, 2007 at 18:28:49:
If the trans is in a gear (proobably the gear it was last in) and is then shifted into another, it will be locked up when the clutch is let out. If it is in that gear, it will move when the clutch is let out in neutral. To repair, it may be necessary to pull the gear shift out as indicated below. The shift rails can be moved to alignment with a big screwdriver. Once aligned, it is best to weld up the bottom corners of the tab on the end of the stick. There are pictures in the archives, but the essence is the tab should be made a bit bigger, then groung down to just work well. If it is hard to get out of gear, try pushing the clutch all the way to its stop. this releases both the TA clutch, and the regular clutch, fully. Full clutch release is important. if it still comes out of gear hard, the TA may need further adjustment. Again the archives are important. Good luck. JimN
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|