Farmall & IHC Tractors Discussion Board |
Re: Farmall 130 steering gear
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on May 30, 2007 at 03:22:05 from (216.208.58.117):
In Reply to: Farmall 130 steering gear posted by Mountain Cabin on May 30, 2007 at 00:48:51:
Mountain Cabin: A lot of offset tractors have been runing for years with grease in the steering gear box. The box was a poor design from the beginning thus most of them leaked oil by the time they were 10 years old. The oil ran down over axle, collected dust and front of tractor was always a mess. I have grease in all my offset tractors, filled them full at the beginning, put a grease zerk in the drain port, and each time I grease the tractors I add abot 6 pumps to the steering box. My 130 has 25 years on it now, and the steering has stayed tight. That is far better than it did when new. I works and works better than gear oil. You already have the best solution, I wouldn't try and fix it.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|