Farmall & IHC Tractors Discussion Board |
Re: 48' Farmall H Traction Tire Size
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CNKS on May 28, 2007 at 06:37:16 from (204.249.178.32):
In Reply to: Re: 48' Farmall H Traction Tire Size posted by Mike in OR on May 27, 2007 at 22:01:45:
It will work, but it is best to have both the same size and same ply rating. Be careful with that chain or strap, if it breaks you might be dead. You can get some of the effect of a locking axle by pushing the brake of the spinning wheel. There is a little difference in the distribution of the power as far as I am concerned. On my 460 (basically an H rear end) I sometimes put it in 5th and jack one or the other sides up to turn the engine over to find TDC, etc. (don't have the hand crank). The right wheel turns much easier than the left.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|