Farmall & IHC Tractors Discussion Board |
Re: At what RPM is peak efficiency (torque) for M?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Cedric on May 28, 2007 at 04:09:16 from (210.54.69.47):
In Reply to: At what RPM is peak efficiency (torque) for M? posted by M.Rad. on May 26, 2007 at 22:18:32:
I have a 1971 reprint of the Blue Ribbon Service Manual for the H & 4 Series tractors which also includes the U-4 Power Unit. As part of the description for the Power Unit there is a graph showing performance curves. Maximum torque of 110 lb.ft. took place at 1200 rpm's at just over 25 hp. As agpilot suggested, the torque curve was fairly flat, ranging from 90 lb.ft. at 600 rpm, up to the maximum of 110 then back to 90 lb.ft. at 1800 rpm. As far as I'm aware the U-4 Power Unit and H engines are identical so these figures should also be applicable to the H. If you can get hold of a Blue Ribbon Manual for the M it should have the I-6 Power Unit in with similar information. Hope this might be of some help. Sid.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|