Farmall & IHC Tractors Discussion Board |
Farmall A PTO question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jesse Garrett on May 27, 2007 at 13:22:38 from (209.209.140.20):
I recently had a problem with trying to get a belt pulley off of a 90 degree angle PTO shaft. The compression ring crumbled and basically left me stuck with the pulley on the shaft with no way to get it off. I finally got around to heating the compression ring with a torch and using a hammer I got the pulley off....the pulley and the PTO look okay BUT the PTO turns hard by hand. I am not sure exactly what I have done. These seem simple enough mechanically. I have taken it apart to lube the bearings with hard grease but after tightening the bolts it turns harder than it should. By heating the PTO, did I somehow warp the bearings? Do I need to replace them? Suggestions?
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|