Farmall & IHC Tractors Discussion Board |
Re: 460 clutch adjustment
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CNKS on May 23, 2007 at 19:44:17 from (204.249.178.32):
In Reply to: Re: 460 clutch adjustment posted by Owen Aaland on May 23, 2007 at 19:24:29:
Thanks, I suppose backwards is the most likely possibility, but I remember looking very closely at the parts manual to make sure it was correct. I can put various shims together to get different thicknesses, but if you say 0.030 is ok, I will do that. Since the old clutch was working, and the flywheel looked good, I don't think that is the problem. If I have to split the tractor, I will have it machined. I suppose I can take out the bolts that hold it to the fly wheel and slide it enough to see if the disk is in backwards, or maybe bent. But, I have a feeling it is something that I have overlooked, just like everything else -- I just don't know what.
Replies:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|