Farmall & IHC Tractors Discussion Board |
Re: 460 clutch adjustment
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CNKS on May 23, 2007 at 17:40:05 from (204.249.178.32):
In Reply to: Re: 460 clutch adjustment posted by the tractor vet on May 23, 2007 at 17:20:09:
When I installed it, it appeared that there was too much clearance between the fingers and the bearing, I turned the adusting screw in 1/2 turn, which if I remember right made the fingers touch the bearing, lightly. So what you are saying is there must be minimal clearance, but the fingers are not supposed to touch the bearing? Thing is, I have tightened the fingers until the bearing was hard to turn (not about to leave it that way) trying to get maximum release of the clutch, and even removed the foot rest so I could push the clutch further, and have lengthed the adjusting rod to the point where I could barely get the pin in -- no difference. All I have been able to do with the various adjustments is that when I shift it into gear and start it, it won't creep with the clutch pedal pushed down. It simply will not disengage enough to shift.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|