Farmall & IHC Tractors Discussion Board |
Re: Fixing my tire... Any suggestions.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by cjd12000 on May 22, 2007 at 07:21:29 from (192.249.47.9):
In Reply to: Fixing my tire... Any suggestions. posted by JayWalt on May 21, 2007 at 07:31:49:
I have fixed 2 flats on my 806 in the last year and to break the bead i use a porta power and park another tractor near the tire i need to break the bead off. I angle the ram on the porta power so i can push the end into the bead and the outside pops of pretty easily then to get the inside i position the ram from the 3 point hitch arms to the bead and pop it off that way. Tubes cost me about 60 but to pay some one to come out and fix it for me would cost about 300. I save 240 and its a little frustrating. To reseat the bead use dish soap not dilluted and make sure you cover the new tube in baby powder so the rust in the rim doesnt stick to it. Good luck and if you dont need the tires loaded leave it out.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|