Farmall & IHC Tractors Discussion Board |
Re: loading an M on a trailer
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CNKS on May 20, 2007 at 18:01:38 from (204.249.178.32):
In Reply to: loading an M on a trailer posted by lineman farmer on May 20, 2007 at 17:49:40:
I live in Garden City, about 100 miles east of you. That tornado and aftermath have been on the national news about every day since then. Worst thing that happened in this area in 50 years. You can reverse one wheel on your M and make it fit. But if you don't like both reversed (I don't either), and you haul a lot, you have to do that every time. Some people load from the front. Others that have strong fenders attempt to drive over them or rest the rears on the fenders themselves, I definitely do not recommend that. Basically, if you have a 3/4 ton pickup, you need a gooseneck or an over the axles type trailer. Those are too heavy for a half ton. I consider an M to be too much for a half ton anyway, (possibly not for the latest models). AND, unless you have a load equalizing hitch, with the rear in front of the fenders there will be too much weight on the back of your pickup.
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|