Farmall & IHC Tractors Discussion Board |
Re: Hello Funderburk1
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on May 17, 2007 at 21:30:32 from (66.173.50.154):
In Reply to: Hello Funderburk1 posted by Tom Windsor on May 17, 2007 at 21:07:36:
Yes blowing a bolt out can happen. It is mostly a matter of heat transfer. Heating a bolt in a blind hole is not going to wirk well. If the casting is made such that the threaded hole is through the back into the air, drilling a hole about 1/2 the diameter of the bolt will allow the flame to travel the length of the bolt. cutting it must be done such that only the bolt is directly heated to any where near red heat. Then the oxygen lever is hit causing the steel of the bolt to burn. this heat (not the torch flame) continues the cutting process. Be sure to blow through the hole and not plug it up. If it gets plugged up, it will have slag inclusions that are hard to drill out. If it were mine, I would drill out the bolt with very careful alignment of the drill (jig/fixture) and centering. then keep using larger bits until I got to the tap drill size. then heat the remaining "springlike" piece of thread with the torch until it glows. Then pull them out with a needle nose and a dentil pick. JimN
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|