Farmall & IHC Tractors Discussion Board |
Re: Draining Rear End
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BF8690 on May 17, 2007 at 09:23:46 from (138.163.0.43):
In Reply to: Draining Rear End posted by Tom Windsor on May 17, 2007 at 09:05:41:
Yeah. The M is same way. Last year I took the top plate off and cleaned it real good. It's amazaing how much junk can be stored behind the bull gears. My wheel seals started leaking after I changed the fluid. It turned out to be a blessing in disguise because both inner axel bearings were toast. That is when I found all the junk built up behind the bull gears. There are a lot of reinforcement ribs that run just about parallel to ground. If you want to clean it out good you really should take the top plate off. That's a leason I learned the hard way.
Replies:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|