Farmall & IHC Tractors Discussion Board |
Re: Farmall differential question......
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ChadS on May 07, 2007 at 06:52:35 from (65.151.84.48):
In Reply to: Re: Farmall differential question...... posted by Wardner on May 07, 2007 at 00:20:25:
We have a limited slip setup, its basicly an axle installed thru the brake pinion shafts with a clutch pack mounted on the end of the installed axle. It locks one side solid, and clutches the other side, holding both pinion shafts turning together. We also have a kit that installs between the bull gears, but you wont have a PTO in a Farmall H-SM. The clutch is fully adjustable, you can tighten it down, and make it more like a locker, or set it to where it just slips a tad for easier turning. Chad
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|